2002 ford f250 7.3 injector driver module

Powertrain Control Module (PCM) keep alive power, Canister vent solenoid (gasoline)ДЄn auxiliary relay box is located on the left-hand front side of the engine compartment. The power distribution box is located in the engine compartment.Дў005, Diesel:В Horizontal Fuel Conditioner Module (HFCM) Trailer tow park lamps, backup lamps (2002)Д¬ircuit Breaker:В Delayed accessory, Power windows, Moonroof Turn lamps (flasher), Brake On-Off (BOO) lampsДў003-2004, Diesel:В Fuel Injection Control Module (FICM) relayДў005-2007:В Trailer tow Electric Brake Controller (EBC)Дў003-2004:В Brake pressure switch, Speed controlДў005-2007:В Tow haul, Blower relay, Electronic Automatic Temperature ControlДў002-2004:В 4-Wheel Anti-lock Brake System (4WABS) module, Variable Fan Control (VFC) (2003-2004, Diesel)Дў002-2004:В EATC module, Front blower relay coilДў002-2004:В Clutch interlock switch (manual transmissions only), Transmission range sensor (automatic transmissions only) then to starter relay coil (all transmissions), 4x4 To reinstall the cover, align and engage the two hooked clips at the bottom of the cover onto the instrument panel, then lift the panel and press the top clips firmly into place. When the top clips of the panel disengage, let the panel fall easily. To remove the fuse panel cover, pull the panel downward by the finger slots on top of the panel. Remove the panel cover to access the fuses. The fuse panel is located below and to the left of the steering wheel by the brake pedal. It is responsible for developing the high-voltage signals necessary to actuate the Hydraulic Electronic Unit Injectors (HEUI) utilized by the Power Stroke engine. The IDM works in conjunction with the vehicles on-board computer. If a fuse blows again contact a qualified service center. Injector Driver Module for 1999 - 2003 Ford 7.3L Power Stroke - Remanufactured IDM.Use always an intact fuse of the same color. Never replace a broken fuse with anything other than a new fuse.Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. Always replace a fuse with one that has the specified amperage rating.Always disconnect the battery before servicing high current fuses.Before replacing fuses check that the key has been removed from the ignition and that all the services are switched off and/or disengaged.

2002 ford f250 7.3 injector driver module